Water jet cut aluminum is bent into brackets used to secure large fiberglass fenders onto the vehicles for inexpensive replacement.
Cam lock assembly prevents dip sticks from being ejected form tube. For use with Cummins QSM11 Diesel engines
This vehicle is able to scrub a train with hot water and a brush, rinse and recycle the wash water to be used again .
This press tool holds aluminum backing plates and mounts replacement bags. It then tests the bead seal before vehicle installation.
This flat pulley puller is designed to fit in limited clearance areas to remove pulleys without the need of draining and R&R pumps.
This aluminum framed jig holds a sensor and spins it at incremental revolutions per minute to verify their performance.
I developed a simple press die to produce a limited quantity of identical square nut retainers for large composite bodywork.
This large spider cradle suspends a 9 ton power bogie at an ergonomic height allowing work to be performed above and below simultaneously.
Portable device used to cool compact converter radiators when mechanical fans are inoperable in maintenance facilities.
Tests aluminum pneumatic storage devices.
Removes and installs light rail diesel / generator assemblies using an overhead gantry crane.
Shipping skid designed to carry multi-ton axle / electric motor combo from maintenance facility to machine shop on a tractor trailer flat bed.
This device is used to measure the force a disc brake caliper applies. It then records and validates against the manufacturers spec.
Stainless shield built to protect large pyrex and plastic round plug assemblies in commercial fueling systems with automatic shut-offs.
This huge devise was developed to measure wake characteristics behind small craft. The data can then populate a 3D model.
Stainless steel device that prevents light rail vehicles from applying power while maintainers are working on or around equipment.
Attaches between electrical components with pigtails to test individual circuits without disrupting assembly functionality.
Jig used to lift large commercial HVAC systems off and on of Stadler rail vehicles. Used with gantry crane to reduce vehicle down times.
Used to transport train axles on flatbed trailers using a forklift only to reduce handling time.
I developed these jigs to locate where preformed stringers are to be installed in performance fiberglass hulls in the lamination department of marine factories.